3” x 3/16” Piston Ring - Oil (STD)

        3” x 3/16” Piston Ring - Oil (STD)

        High quality 3” x 3/16” piston ring suitable for vintage engines with a 3” standard bore. These oil scraper rings (oil control ring) have a radial wall thickness of 0.125”, please check your piston ring grove for suitability before ordering.

        Sold Individually.

        Not rated yet
        0
        • $13.75
        • including GST
         
        In stock(97 items available)

        Piston Ring Type: Oil Control Ring (Slotted/Bevelled Edge)

        Joint: Butt Cut

        Piston Ring Dimensions:

        • Suit 3” (76.2mm) Standard Bore
        • 3/16” (4.76mm) Wide
        • 125” (3.175mm) Radial Wall Thickness (+ - 0.005")


        Known to be Suitable for:

        • Ronaldson & Tippett N Type, 2hp, 1 rings required (Plus 2 x 1/8” or 3/16” Compression Rings).
          Note: The 2hp R&T N Type had a variety of piston ring configurations, please check your piston before ordering.
        • Rosebery/Buzacott C Type, 2hp, 1 ring required (Plus 2 x 1/8” Compression Rings).
        • Wolseley WD, 1.5hp, 1 ring required (Plus 2 x 1/8” Compression Rings).
        • -


        *Radial wall thickness shown is an indication only, this may vary by up to 0.005” depending on stock available at the time. If you require a specific radial thickness, please contact us to discuss your requirements.

        CHECK YOUR PISTON & BORE! Remember, many of these engines can be as much as 80 to 100 years old or more, piston ring groves may be worn or may have even been modified in the past. Be sure to check your engines piston and bore for ring suitability before purchasing.

        The list of suitable engines is intended to be a reference guide only, it may be incomplete and contain errors and omissions.

        Gap Check Your New Rings: All new rings should to be checked for correct minimum end gap requirement suitable for your engines bore, refer to your workshop manual for original manufactures specifications on correct ring end gap required for your engine. In the absence of the original manufacturer’s specifications please refer to the general information pamphlet that is provided with your new piston rings.

        We purchase our new piston rings from several suppliers here in Australia and around the world, as well as purchasing new old stock from closing businesses. Some of our rings are pre gapped, some are not, if you have specific requirements for pre-gapped or ungapped rings please contact us.

        Fitting Piston Rings: Using ring expanders is highly recommended to avoid breaking your new rings or causing damage to the piston, please be sure to read the tips and recommendations on the pamphlet provided with your new piston rings.

        Quality Guaranteed: Our piston rings have been tried and tested and are constantly quality checked, you can rest assured you are buying a high quality product from O.T.E. Parts Australia.

          • SKU
            3000x187x125-OIL-STD
          • Weight
            0.0200 kg
        • Manufacturer
          O.T.E. Parts Australia

        Product questions

        No questions yet. Be the first to ask the question!

        Customers who bought this product also bought

        Customers who viewed this product also bought

        Footer navigation