Breather & Crank Case

A replacement crankcase breather assembly for Lister engines fitted with this style of crankcase breather, including Lister L, J, A & B models, photos 3, 4 and 5 show examples of this style of breather fitted to other Lister engines.

Lister CS decompression lever complete with bolt.

A pack of 25 x No.4 x 1/4" hammer drive rivets, electroplated for protection against the elements. Will suit most vintage Lister engine nameplates and any other stationary engine ID plates where this size is used.

A quality replacement hardened steel diaphragm for the crankcase breather assembly on all Lister CS engines. Will also fit other Lister engines fitted with this style of crankcase breather, including Lister L, J, A & B models, photos 2, 3 and 4 show this style of breather fitted to other Lister engines.

A set of 4 Lister CS cylinder/cylinder head studs, these are the 4 main corner studs that screw into the crankcase, each stud is 17" long and threaded at both ends with 3/4” BSW threads. Equivalent to Lister part number 027-00861 x 4.

Pair of quality black fibre washers suitable for the oil drain plug and oil pump suction pipe joint for all single cylinder Lister CS engines, these will also fit many of the early petrol/paraffin engines, including the Lister J, K, L, M, N, P, Q & R for both the oil drain plug and suction pipe.

A genuine new old stock pump hand lever swivel pin found on single cylinder Lister CS diesels, as well as on Lister J, K, L & M Petrol/Paraffin engines. Lister part number 003-00334.

A pack of 25 x No.4 x 1/4" hammer drive rivets, brass plated to give an authentic vintage look as well as protection against the elements. Will suit most vintage Lister engine nameplates and any other stationary engine ID plates where this size is used.

Genuine brass oil filling plug for camshaft oiling hole on Lister CS engines and oil filling points on some Lister gearboxes. Part number 008-02006, replaces 8-2-6 & 5-1/B6.