Gaskets & Seals

Genuine new old stock Lister CS 5/1, 6/1, 8/1, 10/2, 12/2 & 16/2 head gasket suitable for engines with a 4.5” bore. These 008-03051 gaskets are the later type, made from non-asbestos materials.

These are a high quality head gasket suitable for use on genuine Lister CS engines. They will fit the 5/1, 6/1 and 8/1 single cylinder engines and the 10/2, 12/2 and 16/2 twin cylinder engines (2 gaskets required for the twin cylinder engines).

A very high quality made non asbestos copper laminated gasket for the exhaust flange and inlet joint on all Lister CS & JP diesel engines and the exhaust flange side of early Lister J, K, L & M petrol/paraffin engines.

New crank case door gasket for all single cylinder British built Lister CS engines, and the early Lister J, K, L & M petrol/paraffin engines. Made from high quality 1.5mm thick oil resistant gasket material as per the originals.

Pair of cylinder water jacket door gaskets suitable for all British built Lister CS engines with the water jacket doors fitted to the cylinder/s. Sold in pairs, 1 pair required for single cylinder engines and 2 pair required for twin cylinder engines.

Fuel filter body cover gasket 023-02278, suitable for all British built original Lister CS engines with the original cast iron filter body. May also suit JP and CD engines with this filter body style fitted.

Pair of water outlet flange joints, suitable for all British built Lister CS engines both single cylinder and twin cylinder, 2 pairs required for twin cylinder engines.

Sold in Pairs.

Pair of quality black fibre washers suitable for the oil drain plug and oil pump suction pipe joint for all single cylinder Lister CS engines, these will also fit many of the early petrol/paraffin engines, including the Lister J, K, L, M, N, P, Q & R for both the oil drain plug and suction pipe.

Replacement 5/8" oil seal for Lister CS oil pumps. This seal is a light press fit in top section of the oil pump body and seals around the plunger. Equivalent to Lister part number 008-02178.

Sold Individually

Replacement 1/2" oil seal used for sealing around the oil pump tappet in the bottom section of the Lister CS cam shaft cast housing. Equivalent to Lister part number 088-02177.

Sold Individually

A pair of new crankshaft felt rings for use on original British built Lister CS engines, suitable for 3-1, 3.5-1, 5-1, 6-1, 8-1, 10-2, 12-2 & 16-2 with bush bearings and oil thrower ring. Equivalent to Lister part numbers (x2): 003-00664, 3-664, 3664.

These are genuine new old stock Lister CS and JP rubber injector sealing O-rings, Lister part number 010-03038. These are only required if you have an early CS or JP with the water cooled injector (See Notes).

A genuine Lister VA cylinder base gasket, these copper gaskets seal the joint between the cylinder and crankcase on all Lister VA air cooled diesel engines. Lister part numbers 008-30040 & 8-30-4.

A genuine Lister VA cylinder head gasket, these gaskets are 0.023” thick.

A genuine Lister VA cylinder head bump Shim, these shims are 0.005” thick. Purchased individually, you will need to purchase the amount you require to set correct bump clearance.