Lister LD & SL

Later type aftermarket cartridge fuel filter being a suitable replacement for the assembly found on many Lister Petter engines. This standard AD600 type filter comes complete fitted with the ACD60 paper element P/N 201-13118. Suitable for Lister LD, SL, LR, SR, ST1, ST2, LPA, LPW, LPWS, VA and Later CS 8-1 & 16-2 engines. Also found on many Petter engines.

Gromet for leak off pipe (Fuel Tank End) on Lister LD, SL, LR, SR, ST fuel tanks where fitted. This rubber gromet is equivalent to Lister part number 201-11710. For reference, gromet is item #10 in photo.

A new high quality non-genuine piston assembly for Lister LD1 & LD2 engines with a standard 3” bore. The assembly includes a new piston, ring set, gudgeon pin and pair of circlips. Available in standard size to suit a 3” (76.2mm) bore.

Fuel lift pump suitable for replacing Lister Petter part numbers 351-12150, 329-24810, 329-62200, 572-71980. This type of lift pump is fitted to many Lister Petter diesel engines including the SL2/3, HA2/3, HB2/3, HR2/3, SR, ST & STW models.

A genuine Lister Petter aluminium injector sleeve suitable for all LD & SL models, Lister part number 201-10938.

Genuine Lister swivel union plug (Brass), Lister part number 201-15400. Used on the fuel system of many Lister models including the LD, SL, LR, SR, ST and others.

Oil level dipstick for Lister LD1, SL1, LR1, SR1 & ST1 diesel engines where fitted to crankcase door (Identification Mark 17, refer to parts book to verify). This non-genuine aftermarket dipstick is equivalent to Lister part number 570-10211.  

Genuine Lister SL oil suction valve assembly for 1 and 2 cylinder engines, lister part number 570-10071.

Fuel injector oil seal O ring suitable for Lister LD, SL, LR, SR, HA & HB diesel engines, equivalent to Lister part number 201-11080.

Sold Individually

New fuel pipe for connecting between the fuel tank and fuel filter body on Lister LD1, LD2, SL1, SL2, SL3, LR1, LR2, SR1 & SR2 engines. This high quality aftermarket copper pipe is equivalent to Lister part number 201-11674.

Lister LD, SL, LR & SR cylinder head nut washer, also used in various other applications on a number of other Lister Petter engines, including but not limited to starter motor nut washers on some models etc. Lister part number 027-00545.

Sold Individually.

A good quality reproduction exhaust silencer for Lister LD1 & LR1 engines. These silencers have internal baffles for effective exhaust note silencing.

Genuine Lister fuel leak off pipe for SL3, SR3 & Early ST3 air cooled diesel engines (See notes regarding ST3 engines). Lister part number 203-17131, supersedes part number 203-81940.

Genuine Lister LD, LR, SL, SR, ST & STW SW governor lever fulcrum (Tee), part number 201-10830.

High quality Lister LD2 two cylinder engine full overhaul gasket sets, these aftermarket gaskets sets are equivalent to Lister P/N 657-10053. For air cooled LD2 engines made between 1957 - 1966.

Genuine Lister anti-clockwise flywheel starting ring for Lister LD2, SL2, SL3, LR2, SR2, SR3, ST2 & ST3 diesel engines. Fits 2 & 3 cylinder engines only, not suitable for single cylinder engines.

Lister LD, SL, LR, SR, ST, HA, HB, HW decompression lever shaft assembly suitable for 1, 2 & 3 cylinder engines. Equivalent to Lister part numbers 201-10950 (Shaft), 201-10960 (Screw) & 270-00002 (Nut).

High quality Lister LD1 single cylinder engine De-coke or top gasket sets, these aftermarket and genuine (when available) gaskets sets are equivalent to Lister P/N 657-10002. For air cooled single cylinder LD engines made between 1956 - 1966.

Genuine Lister LD & SL crankshaft oil seal housing, suitable for reverse rotation engines only.
Lister part number 201-12630.

Phosphor bronze camshaft bush (Gear End) suitable for Lister LD, SL, LR, SR & ST engines. This non-genuine bush is equivalent to Lister part number Lister 201-10181.

Sold Individually

Genuine Lister LD & SL cylinder base gasket, suitable for all 1, 2, 3 & 4 cylinder engines in these models, Lister part number 201-10390.

Sold Individually

Genuine Lister lubricating oil relief valve assembly, suitable for Lister SL3, SR3, *ST2 & *ST3 (See Notes Regarding: ST2 & ST3). Lister part number 570-11071, supersedes 570-11070 & 203-12541.

A genuine Lister Petter SL small end or connecting rod bush, suitable for Lister SL1, SL2 & SL3 engines. Lister part number 201-17460.

Lister governor speeder spring, part number 201-10900. Suitable for LD, SL, SR3 engines, speed varies depending on engine, please refer to your engines manual to find if suitable.

Fuel pump delivery valve holder suitable for CAV, PYROX, Bryce & Bosch PF1A & BPF1A type fuel injector pumps. Genuine CAV, part number 7033-97. Used on a wide range of Lister air cooled engines.

Genuine Lister Push Rod 201-10311 (Steel), suitable for 1, 2 & 3 cylinder engines in the Lister LD, SL, LR & SR range. These Steel Push Rods can be used instead of aluminium push rods (201-54440) in the SR range, see notes below on this page. Supersedes 570-10860.

Sold Individually.

Genuine Lister flywheel key to suit all Lister LD, SL, LR, SR engines, single and multi-cylinder. Lister part number 201-26150.

Genuine Lister fuel pump tappet cap for LD, SL, LR, SR, ST & STW diesel engines, Lister part number 201-11440. Refer to image 2 for location of this item.

Sold Individually.

A high-quality reproduction exhaust silencer for Lister ST1, SR1, LD2 & LR2 engines. These silencers are a copy of the original Lister type, made to original Lister specification, with internal baffles for effective exhaust note silencing.

Genuine Lister LD, SL & LR governor control lever spring, Lister part number 201-12330.

Genuine Lister Petter oil filler neck 027-06317, used on many Lister engines including LD, SL, LR, SR, HA, HB, HW, ST, STW, HR, HRW, TS, TL & TR. Supersedes 027-03821 & 27-3821.

Cylinder head cover joint suitable for Lister Petter LD, SL, LR & SR engines, this non-Genuine gasket is equivalent to Lister part number 201-10510.

A high quality cast iron replacement starting handle suitable for most Lister engines requiring a 1.5" crank starting handle with a ratchet pin that engages from the crank’s keyway. Will fit most Lister A & B Juniors, HR, HRW, LD, LR, SL, SR, ST, and SW. Equivalent to Lister part number 201-12510.

Oil bath air filter suitable for Lister LD1, LD2, SL1, SL2 & LR1, LR2, SR1, SR2 engines up to 2000 rpm (Not Suitable for high speed engines running over 2000 rpm). Fits intake manifolds with flanges up to 38mm (1-1/2”).

Clockwise rotation flywheel starting ring suitable for Lister LD1, SL1, LR1, SR1, ST1 diesel engines. Fits single cylinder engines only, not suitable for multi-cylinder engines. Lister part number 201-12870.

High quality Lister LD1 full overhaul gasket set, these aftermarket gaskets sets are equivalent to Lister P/N 657-10013. For air cooled single cylinder LD engines made between 1956 - 1966.

Genuine Lister LR, SR, LD, SL & FR valve tappet, Lister part number 291-21310.

Phosphor bronze crankcase end cover bush suitable for Lister LD, SL, LR, SR & ST engines. This non-genuine bush is equivalent to Lister part number Lister 201-10171.

Sold Individually

Genuine Lister LD & LR cylinder head shim, suitable for LD1, LD2, LR1 & LR2, Lister part number 201-12300. The shim is 0.003” thick, use as many or as few as you need in combination with the head gasket to set the correct cylinder head bump clearance.

Sold Individually.

Genuine Lister phosphor bronze camshaft bush (Flywheel End) suitable for Lister LD, SL, LR, SR & SW engines. Lister part number 201-10190.

Sold Individually