Lister LD & SL

Genuine Lister decompressor lever 351-13550, early brass type, these were later replace by the aluminium type 351-13551, both are interchangeable. Originally fitted to Lister LD, SL, HA, HB and will also fit LR, SR, ST, STW, HR, HRW.

Genuine Lister swivel union plug (Brass), Lister part number 201-15400. Used on the fuel system of many Lister models including the LD, SL, LR, SR, ST and others.

Later type aftermarket cartridge fuel filter being a suitable replacement for the assembly found on many Lister Petter engines. This standard AD600 type filter comes complete fitted with the ACD60 paper element P/N 201-13118. Suitable for Lister LD, SL, LR, SR, ST1, ST2, LPA, LPW, LPWS, VA and Later CS 8-1 & 16-2 engines. Also found on many Petter engines.

Pair of crankshaft thrust washers to fit all Lister Petter LD, SL, LR, SR, SW, LT and LV engines from one to three cylinders. There are 2 trust washers in each engine, this set contains 2, enough washers for 1 engine.

Equivalent to Lister Petter part number: 201-12380 x2

Genuine Lister LD & SL cylinder base gasket, suitable for all 1, 2, 3 & 4 cylinder engines in these models, Lister part number 201-10390.

Sold Individually

Lister LR, SR & LD, SL cylinder head cover assembly suitable for 1, 2 & 3 cylinder engines. The assembly comes complete with filler cap and decompression leaver fitted. Lister part number 201-17423, will also replace and supersedes 201-17420.

Cylinder head stud (long) suitable for all Lister ST, LR, SR, LD & SL diesel engines, fits all single and multi-cylinder engines in these models. A high quality non-genuine part equivalent to Lister part number 201-11042. This longer stud comes complete with female threaded end to accept rocker cover stud.

Sold Individually

Cylinder head stud (short) suitable for all Lister ST, LR, SR, LD & SL diesel engines, fits all single and multi-cylinder engines in these models. A high quality non-genuine part equivalent to Lister part number 201-11052.

Sold Individually

Lister LD, SL, LR, SR, ST, HA, HB, HW decompression lever shaft assembly suitable for 1, 2 & 3 cylinder engines. Equivalent to Lister part numbers 201-10950 (Shaft), 201-10960 (Screw) & 270-00002 (Nut).

Genuine decompressor spring for the cylinder head/rocker cover on Lister LD, SL, HA, HB, LR, SR, HR. Lister part number 201-12270.

Sold Individually (Spring Only).

Oil level dipstick for Lister LD1, SL1, LR1, SR1 & ST1 diesel engines where fitted to crankcase door (Identification Mark 17, refer to parts book to verify). This non-genuine aftermarket dipstick is equivalent to Lister part number 570-10211.  

Genuine Lister flywheel key to suit all Lister LD, SL, LR, SR engines, single and multi-cylinder. Lister part number 201-26150.

Genuine Lister anti-clockwise flywheel starting ring for Lister LD2, SL2, SL3, LR2, SR2, SR3, ST2 & ST3 diesel engines. Fits 2 & 3 cylinder engines only, not suitable for single cylinder engines.

Clockwise rotation flywheel starting ring suitable for Lister LD2, SL2, SL3, LR2, SR2, SR3, ST2 & ST3 diesel engines. Fits 2 & 3 cylinder engines only, not suitable for single cylinder engines. These high quality non-Genuine starting rings are equivalent to Lister 202-12870.

Clockwise rotation flywheel starting ring suitable for Lister LD1, SL1, LR1, SR1, ST1 diesel engines. Fits single cylinder engines only, not suitable for multi-cylinder engines. Lister part number 201-12870.

Fuel filter element suitable for a wide range of Lister Petter engines fitted with the AC Delco AD600 type filter, including the LT, LV, TS, TR, AC, LD, LR, SR & ST range, also found on the later CS 8/1, 16/2 slow speed engines. Equivalent to Lister Patter part number 201-13118.

Genuine Lister fuel leak off pipe for SL3, SR3 & Early ST3 air cooled diesel engines (See notes regarding ST3 engines). Lister part number 203-17131, supersedes part number 203-81940.

New fuel pipe for connecting between the fuel tank and fuel filter body on Lister LD1, LD2, SL1, SL2, SL3, LR1, LR2, SR1 & SR2 engines. This high quality aftermarket copper pipe is equivalent to Lister part number 201-11674.

Bleed screw or air vent screw suitable for CAV, Bryce, Bosch & Pyrox PF1A, BPF1A, FAOAB, FAOAN type fuel injector pumps, found on many single and multi-cylinder stationary engines including Lister’s and others.

Genuine Lister fuel pump clamp for Lister LD, SL, LR, SR, SW, ST, STW, HA, HB, HW, HR, HRW engines, part number 201-11540.

Fuel pump delivery valve holder suitable for CAV, PYROX, Bryce & Bosch PF1A & BPF1A type fuel injector pumps. Genuine CAV, part number 7033-97. Used on a wide range of Lister air cooled engines.

Fuel pump housing door gasket suitable for Lister LD1, SL1, LR1, SR1, SW1 & ST1, equivalent to Lister part number 201-11581.

Genuine Lister fuel pump tappet assembly for LD, SL, LR, SR, SW, ST, STW, HA, HB, HW, HR, HRW diesel engines. Lister part number 570-10030.

Genuine Lister fuel pump tappet cap for LD, SL, LR, SR, ST & STW diesel engines, Lister part number 201-11440. Refer to image 2 for location of this item.

Sold Individually.

Fuel filler cap joint suitable for fuel tank lids fitted to many Lister Petter fuel tanks, including LD, SL, LR, SR, ST and early LT, LV, TX, TL, TS & TR tanks fitted with the 366-00091 style filler cap.  Equivalent to Lister Petter part number 027-06151.

Pair of new fuel tank straps for the smaller 5 Litre (1 Gallon) tanks fitted to Lister LD1, SL1, LR1, SR1 & ST1. These newly made aftermarket straps are made to fit our new 1 Gallon tanks, equivalent to 570-10630, but may not be suitable for some original tanks.

Sold as a pair, 2 x strap assemblies included (As Shown in Photo).

Genuine Lister LD. SL, LR, SR, ST, HA, HB, HR breather assembly, part number 201-10982.

Genuine Lister LD, LR, SL, SR, ST & STW SW governor lever fulcrum (Tee), part number 201-10830.

Genuine Lister LD, SL & LR governor control lever spring, Lister part number 201-12330.

Genuine Lister camshaft end cover for LD, SL LR and SR engines, Lister part number 201-12392.
Note: NOT interchangeable with 201-12390.

Genuine Lister SL oil suction valve assembly for 1 and 2 cylinder engines, lister part number 570-10071.

Governor weight spring suitable for Lister ST, LR, SR, SL diesel engines. Important: NOT suitable for all engine speeds, see further details below on this page for compatible engines. This non-genuine part is equivalent to Lister part number 201-10820.

Sold Individually

Genuine Lister new old stock injector clamp for Lister LD, SL, LR, SR, SW, ST, STW, HA, HB, HW, HR, HRW engines, part number 351-10580.

Injector washer suitable for Lister LD, SL, LR, SR, HA, HB equivalent to Lister part number 010-03041.

Sold Individually.

Gromet for leak off pipe (Fuel Tank End) on Lister LD, SL, LR, SR, ST fuel tanks where fitted. This rubber gromet is equivalent to Lister part number 201-11710. For reference, gromet is item #10 in photo.

A high quality cast iron replacement starting handle suitable for most Lister engines requiring a 1.5" crank starting handle with a ratchet pin that engages from the crank’s keyway. Will fit most Lister A & B Juniors, HR, HRW, LD, LR, SL, SR, ST, and SW. Equivalent to Lister part number 201-12510.

Genuine new old stock Lister fuel tank filler cap suitable for Lister LD, SL, LR, SR, ST, LT, LV, TS & TR engine mounted fuel tanks. This bayonet style filler cap is the later “non-spill” type, Lister part number 366-00091, comes complete with the 027-06151 joint.

A pair of non-genuine fuel tank packing blocks for mounting fuel tanks to the Lister LD, SL, LR SR & ST range of engines. These aluminium packing blocks are equivalent to Lister part number 201-11491, they can also be used as an alternative for the 202-11490 block.

Sold in Pairs.

Genuine Lister LD & LR cylinder head shim, suitable for LD1, LD2, LR1 & LR2, Lister part number 201-12300. The shim is 0.003” thick, use as many or as few as you need in combination with the head gasket to set the correct cylinder head bump clearance.

Sold Individually.

New precision made gudgeon pin suitable for Lister LD1, LD2, LR1 & LR2 engines, this high quality non-Genuine part is equivalent to Lister part number 201-10090.

Pair of gudgeon pin circlips suitable for Lister LD1, LD2, LR1 & LR2 engines, equivalent to Lister part number 201-10100 x 2.

Genuine Lister LD & SL crankshaft oil seal housing, suitable for reverse rotation engines only.
Lister part number 201-12630.