Bearings & Bushes

High quality clean white metal conrod bearing shells to replace your original Lister CS & VA big end bearings. These non-genuine coenecting rod bearings are available in standard size for 2.5' crankpin or undersized in 10 thou increment for where your crank has worn and had a regrind. Select size when ordering.

New high quality white metal bearing shells for early Lister CS 3/1 engines with a 2.25" crank pin. These bearing shells are steel backed, not bronze like the originals, however it does the same job. Available in std or oversized in 10 thou increments for where your crank has worn and had a regrind.

Lister CS bronze small-end (connecting rod) bush, equivalent to Lister part number 008-00471, 5-1/D7A or 8-4-7-1. This bush will fit all CS and engines with a 4.5" bore, including 5-1, 6-1, 8-1, 10-2, 12-2 and 16-2.

Lister CS 3-1 & 3.5-1 bronze small-end (connecting rod) bush, equivalent to Lister part number 208-00019 or 208-19. This bush will fit CS engines with a 3.75" bore, including 3-1 & 3.5-1.

A crankshaft main bearing for original Lister CS engines. This is a high quality white metal bush for use with original Lister engines with 2" diameter crankshaft journals.

Sold Individually

This centre main bush bearing is a high quality made steel backed white metal bearing for use on genuine twin cylinder Lister CS engines. Available in available in standard size or oversized in 10 thou increment. Please select required size from drop down menu below.

Lister CS bronze cam shaft end bush, an often worn part on any well used Lister CS engine, the bush should be replaced when showing any signs of wear. This bush is for the fuel pump/governor end of the camshaft and fits all single cylinder Lister CS engines. The steel bearing for the opposite end of the cam shaft is available separately in our store if required. Please select between Non-genuine and Genuine when ordering.

A quality replacement bronze bush for original Lister CS valve rocker arms. Sold individually. These new rocker arm/shaft bushes will need to be fit press fit to the rocker arm and reamed if some shrinkage occurs.

Equivalent to original Lister Part Number:  008-24165 or 008-24-165, 8/1C14

A new replacement camshaft end bearing for Lister CS engines. This bearing is for the pressed tin cover end of the cam shaft only, the bronze bush for the governor end can be purchased separately in our store. Suitable for all Lister CS engine sizes.