Lister SR Parts

Exhaust silencer suitable for Lister CS, SR3 & ST3 diesel engines and Lister J, K, L, M & B Petrol/Kero engines with a 1.5” BSP thread. Equivalent to Lister Petter part number 102-00101, these high quality reproduction silencers are available in natural finish or powder coated in high temp black paint ready for use.

Fuel lift pump suitable for replacing Lister Petter part numbers 351-12150, 329-24810, 329-62200, 572-71980. This type of lift pump is fitted to many Lister Petter diesel engines including the SL2/3, HA2/3, HB2/3, HR2/3, SR, ST & STW models.

Genuine Lister fuel pump tappet assembly for LD, SL, LR, SR, SW, ST, STW, HA, HB, HW, HR, HRW diesel engines. Lister part number 570-10030.

Crankcase door gasket for Lister ST1 & later SR1 engines, equivalent to Lister part number 201-55350. Please check suitability for SR1 engines, earlier engines made before engine number 118SR123 used a rubber seal.

Genuine Lister swivel union plug (Brass), Lister part number 201-15400. Used on the fuel system of many Lister models including the LD, SL, LR, SR, ST and others.

A well-made aftermarket oil bath air filter assembly suitable for Lister SL3 engines and SR1, SR2, SR3 high speed engines running over 2000 rpm. This assembly fits over flanges/pipes of up to 50mm (2”), or smaller if you use some form of appropriate spacer to fill the void.

Oil bath air filter suitable for Lister LD1, LD2, SL1, SL2 & LR1, LR2, SR1, SR2 engines up to 2000 rpm (Not Suitable for high speed engines running over 2000 rpm). Fits intake manifolds with flanges up to 38mm (1-1/2”).

Genuine Lister anti-clockwise flywheel starting ring for Lister LD2, SL2, SL3, LR2, SR2, SR3, ST2 & ST3 diesel engines. Fits 2 & 3 cylinder engines only, not suitable for single cylinder engines.

Gromet for leak off pipe (Fuel Tank End) on Lister LD, SL, LR, SR, ST fuel tanks where fitted. This rubber gromet is equivalent to Lister part number 201-11710. For reference, gromet is item #10 in photo.

Bleed screw or air vent screw suitable for CAV, Bryce, Bosch & Pyrox PF1A, BPF1A, FAOAB, FAOAN type fuel injector pumps, found on many single and multi-cylinder stationary engines including Lister’s and others.

Injector washer suitable for Lister LD, SL, LR, SR, HA, HB equivalent to Lister part number 010-03041.

Sold Individually.

Exhaust/Intake manifold joint suitable for later Lister SR engines, this non-Genuine gasket is equivalent to Lister part number 201-51040 (See notes & refer to image 2).

Exhaust/Intake manifold joint suitable for Lister LD, SL, LR & SR engines, this non-Genuine gasket is equivalent to Lister part number 201-11131, can also replace 201-11130 (See notes & refer to image 2).

Fuel pump delivery valve holder suitable for CAV, PYROX, Bryce & Bosch PF1A & BPF1A type fuel injector pumps. Genuine CAV, part number 7033-97. Used on a wide range of Lister air cooled engines.

Oil level dipstick for Lister LD1, SL1, LR1, SR1 & ST1 diesel engines where fitted to crankcase door (Identification Mark 17, refer to parts book to verify). This non-genuine aftermarket dipstick is equivalent to Lister part number 570-10211.  

Clockwise rotation flywheel starting ring suitable for Lister LD2, SL2, SL3, LR2, SR2, SR3, ST2 & ST3 diesel engines. Fits 2 & 3 cylinder engines only, not suitable for single cylinder engines. These high quality non-Genuine starting rings are equivalent to Lister 202-12870.

Genuine new old stock Lister fuel tank filler cap suitable for Lister LD, SL, LR, SR, ST, LT, LV, TS & TR engine mounted fuel tanks. This bayonet style filler cap is the later “non-spill” type, Lister part number 366-00091, comes complete with the 027-06151 joint.

Lister LR, SR & LD, SL cylinder head cover assembly suitable for 1, 2 & 3 cylinder engines. The assembly comes complete with filler cap and decompression leaver fitted. Lister part number 201-17423, will also replace and supersedes 201-17420.

Genuine Lister Petter oil filler neck 027-06317, used on many Lister engines including LD, SL, LR, SR, HA, HB, HW, ST, STW, HR, HRW, TS, TL & TR. Supersedes 027-03821 & 27-3821.

Genuine Lister fuel leak off pipe for SL3, SR3 & Early ST3 air cooled diesel engines (See notes regarding ST3 engines). Lister part number 203-17131, supersedes part number 203-81940.

Genuine Lister decompressor lever 351-13550, early brass type, these were later replace by the aluminium type 351-13551, both are interchangeable. Originally fitted to Lister LD, SL, HA, HB and will also fit LR, SR, ST, STW, HR, HRW.

Genuine Lister new old stock injector clamp for Lister LD, SL, LR, SR, SW, ST, STW, HA, HB, HW, HR, HRW engines, part number 351-10580.

Genuine Lister valve rocker lever complete with bush for Lister SR & SW diesel engines. Lister part number 201-50940 (Lever) & 291-20701 (Bush).

Genuine Lister SR & SW cylinder head gasket, suitable for SR1, SR2, SR3 & SR4 air cooled diesel engines, and SW1 & SW2 water cooled engines. Lister part number 201-50610.

Sold Individually

Genuine Lister SR & SW cylinder head shim, suitable for SR1, SR2, SR3, SR4, SW1 & SW2. Lister part number 201-50620. The shim is 0.003” thick, use as many or as few as you need in combination with the head gasket to set the correct cylinder head bump clearance.

Sold Individually.

Genuine Lister SR1 leak-off pipe “Injector to Tee” with self-priming, for engines fitted with lift pumps only. Lister part number 201-17071.

Fuel pump housing door gasket suitable for Lister LD1, SL1, LR1, SR1, SW1 & ST1, equivalent to Lister part number 201-11581.

Genuine Lister SW cylinder base gasket, suitable for SW1 & SW2 water cooled diesel engines only, Lister part number 201-60071.

Sold Individually

Exhaust manifold flange & exhaust joint used on many Lister Petter SR, ST, TL, TS, TR, TX, LPA & LPW engines, equivalent to Lister Petter 366-01287, supersedes 757-15750.

Genuine Lister Ferrule Joint Ring for Lister HRW, STW, SW, HW & JW engines, part number 351-40130. This cylinder head joint ring is used for sealing the water passages between the cylinder barrel and cylinder head on a wide range of water cooled Lister diesel engines.

Oil filler cap joint suitable for the oil filler caps fitted to Lister FR, LD, SL, HA, HB, LR, SR, ST, LT, LV, HR, HL, JA, JW, TX, TL, TS, TR. Equivalent to Lister Petter part number 303-00253.

Fuel filler cap joint suitable for fuel tank lids fitted to many Lister Petter fuel tanks, including LD, SL, LR, SR, ST and early LT, LV, TX, TL, TS & TR tanks fitted with the 366-00091 style filler cap.  Equivalent to Lister Petter part number 027-06151.

Genuine Lister fuel pump tappet cap for LD, SL, LR, SR, ST & STW diesel engines, Lister part number 201-11440. Refer to image 2 for location of this item.

Sold Individually.

Lister LD, SL, LR & SR cylinder head nut washer, also used in various other applications on a number of other Lister Petter engines, including but not limited to starter motor nut washers on some models etc. Lister part number 027-00545.

Sold Individually.

New precision made gudgeon pin suitable for Lister SR1, SR2, SR3, SR4, SW1 & SW2 diesel engines, this high quality non-Genuine part is equivalent to Lister part number 201-50560.

Thermostat suitable for Lister STW, HRW, SW, HW, JW, Early LPW engines requiring a 74 degree thermostat. Equivalent to Lister part number 354-44070, replaces 010-02290, 331511, 354-44072, 354-44071.  For suitability, see notes below or refer to your service manual. If in doubt, please ask before purchasing.

Swivel union plug (Banjo Bolt) used on the fuel system of many Lister engines including LD, SL LR, SR, ST, HA, HB, HR, CS, LPA, LPW, TS, TR. These are quality made 1/4” BSP non-Genuine banjo bolts equivalent to Lister part number 201-15400 (Steel).

Fuel injector leak off pipe suitable for Lister ST2, LR2 & SR2, a well-made non-Genuine assembly equivalent to Lister part number 202-17131.

Clockwise rotation flywheel starting ring suitable for Lister LD1, SL1, LR1, SR1, ST1 diesel engines. Fits single cylinder engines only, not suitable for multi-cylinder engines. Lister part number 201-12870.

Decompressor lever, later aluminium type equivalent to Lister Petter 351-13551, commonly fitted to Lister LR, SR, ST, STW, HR & HRW. These well-made non-Genuine decomp levers are Nikel plated and come complete with a mills pin for fitting.

Lister LD, SL, LR, SR, ST, HA, HB, HW decompression lever shaft assembly suitable for 1, 2 & 3 cylinder engines. Equivalent to Lister part numbers 201-10950 (Shaft), 201-10960 (Screw) & 270-00002 (Nut).

Genuine Lister phosphor bronze camshaft bush (Flywheel End) suitable for Lister LD, SL, LR, SR & SW engines. Lister part number 201-10190.

Sold Individually

Genuine Lister lubricating oil relief valve assembly, suitable for Lister SL3, SR3, *ST2 & *ST3 (See Notes Regarding: ST2 & ST3). Lister part number 570-11071, supersedes 570-11070 & 203-12541.

New Lister Petter SR cylinder barrel, suitable for all SR1, SR2 & SR3 engines with an 88.90mm bore. These high quality non-genuine cylinders are equivalent to Lister Petter part number 201-50632.

Genuine new old stock Lister SR & SW piston assembly. Includes piston, rings, gudgeon pin & clips. Available in standard and oversize, select size required when ordering.

Top quality Lister SR piston assembly, suitable for Lister SR1, SR2 & SR3 engines with an 88.9mm bore. This new aftermarket assembly includes piston, rings, gudgeon pin and circlips. Available in Standard and 0.010”, 0.020”, 0.030”, 0.040” Over Size, select required size when ordering.

Genuine Lister Petter SR piston ring set part number 570-12140, available in standard and oversize. Select size from dropdown list when ordering.

Lister SR piston ring sets, suitable for all SR1, SR2 & SR3 engines, also suitable for the SW range. These high quality non-genuine piston ring sets are equivalent to Lister part number 570-12140, /010, /020, /030 & /040. Available in standard to suit 3.5” bore & oversizes up to 0.040”. Select size required when ordering.